河南平顶山某17层住宅建筑给排水施工图设计毕业论文

 2021-04-12 11:04

摘 要

本设计是某17层民用住宅楼的建筑给排水设计,主要包括给水系统、排水系统,消防系统,喷淋系统四个部分。

给水系统采用分区供水,1到6层为低区,由市政管网直接供水;7层到12层为中区,13到17层为高区,采用下行上给的供水方式,低区由市政管网直接供水,中区和高区的供水从地下一层的水池中通过变频泵加压供水到中区和高区。

排水系统采用的是污、废合流制,底层单独排水,排水立管设专用通气管,污水排向市政污水管网。

消防系统采用消火栓灭火系统,火灾初期10min的水由消防水箱供给,正常供水由消防水泵从贮水池内抽取,室外设水泵结合器。

喷淋系统布置在地下一层,设水泵接合器,与消防共用水箱,水池。

关键词:高层建筑;建筑给排水设计;消火栓系统设计;喷淋系统设计。

A 17th floor residential building water supply and drainage construction design for Henan pingdingshan

ABSTRACT

This design is a 17th floor civilian residential building water supply and drainage design, including water supply system, drainage system, fire control system and spray system in four parts.

Water supply system using water rationing, 1 to 6 for low area, water supply directly by the municipal pipe network;7 to 12 layers for the central district, 13 to 17 layer is high area, the descending on water supply way, low area water supply directly by the municipal pipe network, the central and high the water from underground pool through variable frequency pump high pressure water supply to the central and district.

Drainage system is corrupt, waste confluence system, the underlying separate drainage, drainage riser set special ventilation tube, the sewage to the municipal sewage pipe network.

Fire hydrant extinguishing system is adopted in the system, the initial 10 min by fire water tank water supply, by the fire pump from normal water supply reservoir in extraction, outdoor set pump joint.

Spray system layout in the underground, water pump adapter, Shared with fire water tank and water pool.

Key words:high building; water supply and drainage of buildings; fire control,spray.

目 录

1 设计过程说明 1

1.1 给水工程 1

1.2 排水工程 1

1.3 消防系统 2

1.4 管道的平面布置及管材 2

2 给水设计计算 3

2.1 设计参数 3

2.1.1 最高日用水量 3

2.1.2 最大小时生活用水量 3

2.1.3 设计秒流量 3

2.2 水力计算 4

2.2.1 低区给水管网水力计算 5

2.2.2 校核市政管网压力是否满足 10

2.2.3 中区给水管网水力计算 11

2.2.5 中区给水泵的选择 17

2.2.5 高区管网水力计算 18

2.2.6 高区水泵的选择 25

2.3 其他给水附属构筑物计算 26

2.3.1 水池的计算 26

3 消防系统的计算 27

3.1 消火栓的基本参数 27

3.1.1 消火栓的保护半径 27

3.1.2 水枪喷嘴处所需的水压 27

3.1.3 水枪喷嘴处的出流量 27

3.1.4 水带阻力 27

3.1.5 消火栓口所需要的水压 28

3.1.6 校核 28

3.2 消防水力计算 28

3.2.1 消防给水管网水力计算 28

3.2.2 其他附属构筑物计算 30

4 建筑内部排水系统的计算 32

4.1 排水计算 32

4.1.1 污水立管确定 32

4.1.2 废水立管计算 33

4.2 排水管径选择 34

5 自动喷水灭火系统设计与计算 36

5.1 基本参数 36

5.1.1 喷头的选择 36

5.1.2 报警阀 36

5.1.3 自动喷水灭火系统的基本设计数据 36

5.1.4 管径确定 36

5.2 管网水力计算 37

5.2.1 管段沿程水头损失 37

结 论 41

致 谢 42

参考文献 43

1 设计过程说明

1.1 给水工程

由于高层建筑对消防给水的安全可靠性能要求严格,故高层建筑应独立设计生活给水系统、消防给水系统。高层建筑,若只采用一个给水系统供水,建筑低层的配水点所受的静水压力很大,易产生水锤,损坏管道及附件,流速过大产生水流噪音;低层压力过大,开启水龙头时,水流喷溅严重;使用不便。因此高层建筑给水系统必须分区。设计任务书给定了市政给水管网提供常年的水压为0.28MPa。根据给水最小所需压力估算方法:第一层0.10MPa,第二层0.12MPa,二层以上增加一层压力需增加0.04MPa。得0.28MPa的压力能直接供到第六层。所以1到6层为低区,上面7到12层为中区,13到十七层为高区,总共三个区。1到6层用市政管网直接供水,中区和高区由水泵加压供水。

考虑到屋顶水箱有消毒,以及二次污染等问题,所以考我虑使用设水泵直接加压给水方式,当室外管网压力足够大的时候,可自动开启旁通管的止回阀直接向建筑内供水。因水泵直接从室外管网抽水,会使外网压力降低,影响附近用户用水,严重时还有可能造成外网负压,在管道接口不严密时,其周围土壤中的渗漏水会吸入管网,污染水质。当采用水泵直接从室外管网抽水时,必须征得供水部门同意,并在管道连接处采取必要的防护措施,以免污染水质。为避免上述问题,可在系统中增设贮水池,采用水泵与室外管网间接连接的方式。

这种给水方式避免了上述水泵直接从室外管网抽水的缺点,城市管网的水进入贮水池,然后经水泵加压后再送往室内管网。

您需要先支付 80元 才能查看全部内容!立即支付

课题毕业论文、开题报告、任务书、外文翻译、程序设计、图纸设计等资料可联系客服协助查找,优先添加企业微信。